Contact
Site map
Legal information
Torque sensor
0160/01 DM - Torque sensor
- Range from 0.2 to 5,000 Nm (1.8 in.lbs to 44,200 in.lbs)
- Precision: 0.2% capacity
- Brushless technology
- Output signal +/- 5VDC
- Rotation speed 50,000 rpm max
- Rotation angle measurement
- Option : installation housing
The torque sensor 0160 series is designed with a rotation shaft supported by bushings. The torque signal is transmitted from the rotating shaft via frequency modulation without contact.
Its low cost and high precision is ideal for bench test equipement.
| Technical specification | ||
|---|---|---|
| Band pass | kHz | <= 1 |
| Consumption | mA | 200 |
| Sensitivity creep on compensated range | %/°C | 0.01 |
| Zero creep on compensated range | %Em/°C | 0.005 |
| Hysteresis deviation | %EM | 0.1 |
| Linearity deviation | %EM | 0.1 |
| Sealing | IP 40 | |
| Capacity | Nm | 0,2-0,5-1-2-5-10-20-50-100-200-500-1000-2000-5000 |
| Speed measurement | Pulses/tour | 60 |
| Output signal | Vdc | +/- 5 |
| Safe overload | %EM | 130 |
| Operating temperature | °C | 0 to +70 (32°F to 160°F) |
| Excitation voltage | V | 16 to 30 |
| Rotating speed | tours/min | Depending on model (see table) |
Outside dimensions
Options
Installation housing (option GU)
Wiring
12 pins male DIN connector for all models
| Prise | |
| A | - Alimentation |
| B | NC |
| C | + Mesure couple (+/- 5VDC) |
| D | - Mesure couple |
| E | - Mesure vitesse |
| F | + Alimentation (16 30VDC) |
| G | NC |
| H | +Mesure vitesse (60 pulses/tour) |
| J | NC |
| K | Cran de calibration |
| L | NC |
| M | GND boitier |
