Contact
Site map
Legal information
ELECTRONIC of CONDITIONING
ME 5200 CR - Signal conditionner/amplifier
- Designed for gages sensors or potentiometer sensors
Integrated shunt calibration
3 position gain switch
Scale adjustable with potentiometer
LCD voltage meter integrated - 3 ½ digits
The MB 2001 conditioner is designed to be associated with a large range of gage sensors (pressure, load, torque, displacement) and potentiometers.
| Technical specification | ||
|---|---|---|
| Excitation voltage | V | 220 - 50 Hz |
| Sensor excitation voltage | 4 to 12 V regulation 10 puissance-5 (factory setup 10V) | |
| Band pass | 0-15 KHz (500 Hz factory setup) | |
| Consumption | mA | 50 |
| Calibration reference resistor | By conter voltage 1 mV/V (gages) - 10 mV/V (semi-conductors) et 100% (pot.) | |
| Input resistance | Ohm | > 10 power 12 |
| Zero range | ± 10% range minimum | |
| Output signal | Vdc | 0-10V (20 mA maximum) |
| Operating temperature | °C | 0 to +50 (32 to 120°F) |
| Storage temperature | -10 to +70°C (14 to 160°F) | |
Installation
Rack system heigh 3U - width 10 F (1 F = 5.08 mm)
Sensor connection on AMPHENOL 4 pin base connector
Analog output on isolated BNC base
Power 220 Volts on standard CEE22 plug with integrated fuse
