Contact
Site map
Legal information
SENSORS of FORCE and WEIGHING
FAM 100 - Hand brake force sensor
- Range 100 daN
- Hand break measuring devive
- Not sensitive to position of hand on the device
The load sensor FAM 100 is designed to measure tension force on vehicule hand brakes. The double bend design equiped with standard gages is not sensitive to the pressure point of the operators fingers. The device is fixed through a M8 thread on an adaptor for each type of vehicule.
| Technical specification | ||
|---|---|---|
| Sensitivity creep on compensated range | %/°C | < 0.02 |
| Zero creep on compensated range | %Em/°C | < 0.015 |
| Hysteresis deviation | %EM | <= ± 0.1 |
| Linearity deviation | %EM | <= ± 0.2 |
| Sealing | IP 65 | |
| Capacity | daN | 100 |
| Input resistance | Ohm | 350 |
| Output resistance | Ohm | 350 |
| Electrical insulation | MOhm | > 5000 |
| Material | Body aluminium alloy Cover stainless steel | |
| Sensitivity at full range | mV/V | 2 ± 10% |
| Safe overload | %EM | 150 |
| Operating temperature | °C | -10 to +60 (14°F to 140) |
| Compensated temperature | °C | +10 to +60 (50°F to 140°F) |
| Excitation voltage | V | 10 |
Outside dimensions
Options
Support for hand break
Wiring
Output 4 conductor cable length 2 meters
Other length upon request
| Câble | |
| Rouge | + Alimentation |
| Bleu | - Alimentation |
| Jaune | + Mesure |
| Blanc | - Mesure |
