Contact
Site map
Legal information
PRESSURE SENSORS and TRANSMITTERS
PI 103 SC - Pressure sensor
- Relative pressure from 0-2 bars to 0-700 bars
- All parts stainless steel
- Excellent mechanical properties
- Semiconductor gages
The PI 103 series are manufactured out of stainles steel.
The sensing area is part of the sensor body and allows for all types of envirements.
| Technical specification | ||
|---|---|---|
| Sensitivity creep on compensated range | %/°C | ± 0,02 |
| Zero creep on compensated range | %Em/°C | ± 0,02 |
| Initial imbalance | %Em | ± 2 |
| Hysteresis deviation | %EM | ± 0,15 |
| Linearity deviation | %EM | 0,3 |
| Capacity | bars | 2, 5, 10, 25, 50, 100, 250, 350, 500, 700 |
| Input resistance | Ohm | About 1000 |
| Output resistance | Ohm | 500 |
| Electrical insulation | MOhm | > 1000 under 40 V |
| Material | Stainless steel | |
| Hydraulic installation | female Ø 16mm pitch 150 | |
| Sensitivity at full range | mV/V | about 10 |
| Safe overload | %EM | 200 |
| Operating temperature | °C | - 20 + 100 |
| Excitation voltage | V | 10 |
Outside dimensions
Options
out of catalog ranges
Integrated Shunt calibration
Hydraulic male connector inserted
Hydraulic male connector welded
Linearity and hysteresis < ± 0,25 % range
High temperature T1 : 120° C
High temperature T2 : 150° C
Installation
Use an hydraulic connector between the sensor and the installation connector. Make sure this connector has no contact with the diaphragm located at the end of the Ø 16mm thread pitch 150.
Seal with a flat ring BS type.
Wiring
Output with Jaeger 43082 connector
(Male plug and cord grip included)
| Prise | |
| 1 | + Alimentation |
| 3 | - Alimentation |
| 4 | + Mesure |
| 2 | - Mesure |
