Contact
Site map
Legal information
PRESSURE SENSORS and TRANSMITTERS
PE 102 SC - Diaphragm pressure sensor
- Relative pressure frm 0-2 bars to 0-500 bars
- Diaphragm design
- All parts in stainless steel
- Semiconductor gages
The PE 102 series pressure sensors are designed for static and dynamic measurements. The sensor may be inserted close to the pressure point et avoid dead volumes.
| Technical specification | ||
|---|---|---|
| Sensitivity creep on compensated range | %/°C | ± 0,02 |
| Zero creep on compensated range | %Em/°C | ± 0,02 |
| Initial imbalance | %Em | ± 2 |
| Hysteresis deviation | %EM | ± 0,15 |
| Linearity deviation | %EM | 0,35 |
| Capacity | bars | 2, 5, 10, 25, 50, 100, 250, 350, 500 |
| Input resistance | Ohm | About 1000 |
| Output resistance | Ohm | 500 |
| Electrical insulation | MOhm | > 1000 under 40 V |
| Material | Stainless steel | |
| Hydraulic installation | Diaphragm design | |
| Sensitivity at full range | mV/V | 10 |
| Safe overload | %EM | 200 |
| Operating temperature | °C | - 20 to + 100 |
Options
Out of catalog range
Installation
To take full advantage of the diaphragm design, the sensor must be installed as close as possible to the measuring point to avoid dead volumes. Use a Oring Ø 23,7mm to seal, and tighten the sensor through the upper part
Wiring
Output through 4 wire braided cable, length 1 meter.
(Other lengths upon requests)
| Version câble | |
| Rouge | + Alimentation |
| Bleu | - Alimentation |
| Jaune | + Mesure |
| Blanc | - Mesure |
