Contact
Site map
Legal information
PRESSURE SENSORS and TRANSMITTERS
PI 103 - Pressure sensor
- Relative pressure from 0-2 bars to 0-700 bars
- All parts stainless steel
- Excellent mechanical design
- Standard gages
The PI 103 series of pressure transducer are manufactured out of stainless steel.
The pressure sensitive area is part of the sensor body and allows for a large range of corrosive environments
| Technical specification | ||
|---|---|---|
| Sensitivity creep on compensated range | %/°C | ± 0.02 |
| Zero creep on compensated range | %Em/°C | ± 0.015 |
| Initial imbalance | %Em | ± 2 |
| Hysteresis deviation | %EM | ± 0.1 |
| Linearity deviation | %EM | 0.25 |
| Capacity | bars | 10, 25, 50, 100, 250, 350, 500, 700 |
| Input resistance | Ohm | 350 |
| Output resistance | Ohm | 350 |
| Electrical insulation | MOhm | > 1000 under 40 V |
| Material | Stainless steel | |
| Hydraulic installation | Female Ø M16 pitch 150 | |
| Sensitivity at full range | mV/V | 1.5 to 2 |
| Safe overload | %EM | 150 |
| Operating temperature | °C | - 20 to + 120 (-4°F to 250°F) |
| Excitation voltage | V | 10 |
Outside dimensions
Options
Out of catalog standard range
Integrated shunt calibration
Hydraulic male connector inserted
Hydraulic male connector welded
Linearity and hysteresis < 0.25% range
Hight temperature T1 : 120° C
Hight temperature T2 : 150° C
Installation
Use an hydraulic connector between the sensor and the installation connector. Make sure the connector has no contact with the diaphragm located at the end of the thread Ø 16
Use a flat seal BS type to secure the connection
Wiring
Output through a Jaeger 43082 connector (male plug and cord grip included)
| Prise | |
| 1 | + Alimentation |
| 3 | - Alimentation |
| 4 | + Mesure |
| 2 | - Mesure |
