Contact
Site map
Legal information
PRESSURE SENSORS and TRANSMITTERS
PE 101 R - Pressure sensor
- Ranges from 10 bars to 500 bars
Reduced size
Stainless steel
Operating temperature up to 160°C
The PE101 series pressure sensors are manufactured with corrosion resistant stainless steel.
| Technical specification | ||
|---|---|---|
| Sensitivity creep on compensated range | %/°C | ± 0,02 |
| Zero creep on compensated range | %Em/°C | ± 0,02 |
| Initial imbalance | %Em | ± 2 |
| Hysteresis deviation | %EM | ± 0,15 |
| Linearity deviation | %EM | 0,2 |
| Capacity | bars | 10, 25, 50, 100, 250, 350, 500 |
| Input resistance | Ohm | 360 ± 10 |
| Output resistance | Ohm | 350 |
| Electrical insulation | MOhm | > 1000 sous 40 V |
| Material | Stainless steel | |
| Hydraulic installation | Ø 16mm pitch 150 female thread | |
| Sensitivity at full range | mV/V | 1,5 to 2 depending on range |
| Safe overload | %EM | 150 |
| Operating temperature | °C | - 20 + 80 : PE 101 standard - 20 + 140 : PE 101 T1 -20 + 160 : PE 101 T2 |
| Compensated temperature | °C | + 10 + 70 : PE 101 standard + 10 + 120 : PE 101 T1 + 10 + 150 : PE 101 T2 |
| Excitation voltage | V | 10 |
Outside dimensions
Options
Option PE 101 R T1
Option PE 101 R T2
With male hydraulic connector
Additional cable length
Extended ranges out of catalog specifications
Wiring
PE 101 standard: Output with 4 wires protected cable of 1 meter length or DIN base connector, both sides provided.
option T1 and T2: Output with Teflon cable of 1 meter length.
| Version câble | Version Prise | |
| Rouge | + Alimentation | 1 |
| Bleu | - Alimentation | 3 |
| Jaune | + Mesure | pin plate |
| Blanc | - Mesure | 2 |
